twisted.internet.abstract.FileDescriptor

The connection was lost.

This is called when the connection on a selectable object has been lost. It will be called whether the connection was closed explicitly, an exception occurred in an event handler, or the other end of the connection closed it first.

Clean up state here, but make sure to call back up to FileDescriptor.

Called when data is available for reading.

Subclasses must override this method. The result will be interpreted in the same way as a result of doWrite().

File Descriptor number for select().

This method must be overridden or assigned in subclasses to indicate a valid file descriptor for the operating system.

Get the remote address of this connection.

Treat this method with caution. It is the unfortunate result of the CGI and Jabber standards, but should not be considered reliable for the usual host of reasons; port forwarding, proxying, firewalls, IP masquerading, etc.

Close the connection at the next available opportunity.

Call this to cause this FileDescriptor to lose its connection. It will first write any data that it has buffered.

If there is data buffered yet to be written, this method will cause the transport to lose its connection as soon as it's done flushing its write buffer. If you have a producer registered, the connection won't be closed until the producer is finished. Therefore, make sure you unregister your producer when it's finished, or the connection will never close.

Undocumented

Pause producing data.

Tells a producer that it has produced too much data to process for the time being, and to stop until resumeProducing() is called.

Resume producing data.

This tells a producer to re-add itself to the main loop and produce more data for its consumer.

Start waiting for write availability.

Call this to have this FileDescriptor be notified whenever it is ready for writing.

Stop consuming data.

This is called when a producer has lost its connection, to tell the consumer to go lose its connection (and break potential circular references).

Stop producing data.

This tells a producer that its consumer has died, so it must stop producing data for good.

Stop waiting for read availability.

Call this to remove this selectable from being notified when it is ready for reading.

Stop waiting for write availability.

Call this to remove this selectable from being notified when it is ready for writing.

Reliably write some data.

The data is buffered until the underlying file descriptor is ready for writing. If there is more than self.bufferSize data in the buffer and this descriptor has a registered streaming producer, its pauseProducing() method will be called.

Reliably write a sequence of data.

Currently, this is a convenience method roughly equivalent to:

    for chunk in iovec:
        fd.write(chunk)

It may have a more efficient implementation at a later time or in a different reactor.

As with the write() method, if a buffer size limit is reached and a streaming producer is registered, it will be paused until the buffered data is written to the underlying file descriptor.

Write as much as possible of the given data, immediately.

This is called to invoke the lower-level writing functionality, such as a socket's send() method, or a file's write(); this method returns an integer or an exception. If an integer, it is the number of bytes written (possibly zero); if an exception, it indicates the connection was lost.